Contact Us
| Installed on 2012 Wing! And Oh Boy! These look so good! Get them! No brainer to install but they just Bling like crazy!! |
| Installed on my 2012 Wing. Looks really good and adds some nice bling to that area.. The glue is some of the best I've used yet! And you only get one chance so get it right. I started at the top and laid it down very slow went on perfect.. Look and feels of very good quality. |
| Installed on 2012 Wing! And they look great! No brainer to install and I have to say they have some of the best double sided tape so far. Very sticky and add a lot of style to that area. Get these you'll love them.. |
| I tried to install these on my 2012 Wing and they would not go on! I took that metal piece out and installed it in chrome ones and it would not fit on! Also like Coyote79 said I didn't like the feel of these either. I can see them being slippery. And they are smaller then stock also. |
| When this was on it worked well. But when I added the clam-shell ISO grips the throttle boss lasted for only about 50 miles and then slid off when I was on cruise control and my hand was off of the grip. |
| I love how these "finish" off the look of the black ISO grips and really enjoy the weighted ends in helping me in turns. They appear to be well machined, a quality product. |
| I love the look of these and the larger diameter are a real blessing on these old hands. I am disappointed in the very poor heat transfer. I just do not get the heat through them that I was expecting. I also found the tolerances to be less then ideal so even when installed carefully there was still a slight gap on one in the middle (BUT not the other, go figure!). |
| Excellent quality. Much easier install than I was anticipating on my comfort navi 08 wing. Can't wait to take that next trip. |
| Very nice shirt - Love it! |
|
This is a great piece and can be installed in ten minutes. - A 10mm socket to remove two bolts on each side, gently pull out on each side so you can slip the belly pan back piece inbetween. Start the bolts, but don't tighten yet. - Slip the front belly pan piece in on the front side, tighten the two aircraft screws. - Slide back piece front or back to fit and then tighten the four bolts. - Remove the front piece so you can bend the ends slightly up by hand to fit the back belly pan section as needed. |
| Installed these in accordance with the supplied instructions and had no trouble at all. Perfect fit! I might trim down a bit if the lid continues to be hard to close though. |
| Very nice bling, easy install. |