Contact Us
| I have used these DVD's many times with great success. I have saved more than they cost, many times over. Worth the price!! |
| Really nice piece, just do not understand why so much for shiny plastic. Does add a real nice look. Should look really good with lights in them. |
| I run a 2008 with E-3's. My brother runs a 2012 with the Bridgestones shown here. We were comparing wear yesterday, brother has 8,000 miles on his bike, (mostly without a passenger) He needs a new rear tire now-- center three inces is flat and slick. His front tire shows little wear. My E-3's have 13,000 on them now, mostly two up riding, and I'm certain to make it to 18,000. My rear tire won't be in nearly as bad condition(maybe inch center flat) as the stones are already with only 8K. We both do good tire maintenance and ride about the same way and on the same trips. I will definitely be replacing by dunlops with dunlops. Yes, they make a little noise, but that's the only negative and it's not significant enought for me to give up that kind of mileage. |
| Put these on my 2008 wing trunk and saddle bag it really dressed up the back of the bike,looks really nice and have got alot of compliments on them.Another great add-on... |
|
This went much easier than I thought with the help of my Brother-in-law And we are looking forward to the install on his 01GL 1800, as we discussed It did go very good with team work, as for closing the lid as per the directions, worked very well for me Remember “read the instructions.†|
| This went on in no time, just make sure you don't drop your mirror |
| Baker Air Wings: Put off putting these on for a while!!! Do not like the idea of drilling holes I my Wing, still have tears in my eyes from installing Utopia Backrest. But put them on today and took about 20 min. should have done it sooner! Nutting to it ïŠ |
| covered up the scratches on the bike and that is what I was after. Bonus is that they look Great as well. Do lots of measuring to get them even on both side but can be done if you take your time. |
|
This is my second one (first one on an '08)and I had some issues on the first. This one however, was a total pain. It ended up taking about 3 1/2 hours. At the end of my frustration, I did find a simple solution. Take a crescent wrench and bend the bottom tab on the side braces, backwards (to the back of the bike) which will allow the front of the bracket to raise up to the bolt under the floor boards. This seems to be the biggest cause of things having to be pried or forced into place. It seems these tabs are welded on at just a little bit of the wrong angle, which throws everything out of whack. |
| Man what a difference it makes to my front fender, it matches the air intake accent perfectly. The instruction says the product mey need to be tweaked to fit, I found that not the case. If the product don't fit try it on the otherside which is what I did and they both fit fine. It took longer to clean the area than the install. |
| This was a replacement to the one in my helmet. Earlier it was noted by a person about the solder pad and the wires breaking there. That happened to my original set but with a N104 helment the other options are outrageous priced. I was incredibly happy to see the new one has that issue resolved and the improvement is great. Love to have the headset working as designed again. |
| I ended up thinking I was just saving money and getting the "cheap" one. It came in today, I installed the vent sitting at my desk and couldn't wait to leave work to install it. Installed on teh bike tonight and what a differance. Very happy with my selection. |