OUT OF STOCK
-
Chrome Side Fairing Intake Accent for GL1800
By Add On SKU: AO451696
- $104.99Save $24.96
MSRP: $129.95
6 Member Reviews
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
07.29.2020
5 Stars
It was easy to installed |
Was this helpful?
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
06.15.2020
5 Stars
This is a bling and bring my bike out |
Was this helpful?
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
06.09.2020
5 Stars
Wow, these intake was e0asy to installed and it really bring out my Goldwing 1800 |
Was this helpful?
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
02.10.2015
5 Stars
Installed per instructions using the snap ties. I also put 4 good size dabs of Loctite brand clear silicone sealant on the inside of the center ridge (the sealant I use for all my trim work). After removing the temporary ties after the silicone cured, they look awesome with no gaps. The included tape on the grills keep them from moving around while the sealant dries. The silicon sealant gives the permanent holding power. I also installed the upper chrome trim piece and the combo looks great but that piece is not shown on this site? Be sure to put little pieces of blue low tack painters tape around the edges for the trial fit so the permanent install is easy to line up. |
Was this helpful?
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
02.06.2015
1 Star
Tried this again with good 3m double sided tape and better silicone. Let it set for 48 hours tied on. 70+ degrees. It gaped again all the way around it and pulled right off. There is not enough contact area around the edges to hold this on. You basically have the center part holing it and that's it. A big fat 0 for this part but but an A+ to Wingstuff for taking care of me. |
Was this helpful?
Chrome Side Fairing Intake Accent for GL1800
ITEM CODE: AO451696, SKU: AO451696
01.30.2015
1 Star
Put on as instructed 65 degrees, used their silicone and tape. They say zip tie it for 12 hours. First of all it gaps along the top and bottom with no way to tape/glue. Gaps a little on the corners as well. Anyway, I take off the zip ties after 24 hours. The intake accents come off as well. When looking at it, there is not much for contact points. Looks good while holding it in place but the design sucks. Will be sending this POS back. |
Was this helpful?