TOP REVIEWED
-
Rubber Baby Buggy Bumpers for GL1800
By Pakit Rak SKU: PRRBBB
- $12.99
-
-
-
Your Bike
Will this fit your bike?
-
172 Member Reviews
1 Star: 16
2 Stars: 10
3 Stars: 8
4 Stars: 33
5 Stars: 105
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.23.2009
5 Stars
work great and about a 10 minute job. Wish I had these a couple years earlier to help save the paint. Very tight fit but no movement and will hopefully wear down a little. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.19.2009
4 Stars
Great product, trunk is more tight than I like, but dosen't rattle or rub paint anymore.. Gave it a 4 rating, only because the pattern sent with it to drill holes, doesn't say if you have to cut at top of line,facing front? Just says to cut on dotted line, and there is a 1/8 gap at top of pattern, so dont know if it should be trimmed off or left on,,,I trimmed, and sets hole father down on truck, it works, but don't know if inventor wanted it up higher or lower? Im sure it will loosen up on yightness as it stays closed for while.. Great idea, and agree it should have come from factory! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.18.2009
5 Stars
Such a low cost part and I don't know why Honda don't make it a standard compponent to the motobike. I works very well that it completely eliminates the rattling and when I close the hatch it sounds like a Mercedes Benz door LOL. A good thing . |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.13.2009
5 Stars
Work perfect, especially if you have rack on, no more lid movement, simple install, don't worry, just drill on the marks you make, I used a finishing nail and a tack hammer to mark the spots. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.09.2009
5 Stars
Installation was easy and as everyone else stated here, they should be standard equipment from Honda. Now my trunk lid closes properly and no more scratched paint. Buy these for your GL1800, you need them! John |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.02.2009
5 Stars
This is a very inexpensive yet effective remedy to the trunk lid chaffing and rattling problem on the 1800’s. I followed the installation instructions precisely and my installation was very smooth, taking only about 15 minutes. TIP: Dishwashing liquid (recommended in the instructions) as a lubricant did make the insertion of the bumpers fairly easy. Bottom line, it’s a clean look AND it works! Great product!!! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.29.2009
5 Stars
They work great.My trunk is no longer getting the paint scuffed off.The only problem is if you use your trunk remote.It pops open hard you can tell its stressed.The directions do tell you to hold you hand on trunk and push down when opening.I do that and have had no problems. Just wish I had them from day one! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.26.2009
5 Stars
When I bought my 2004 I was very annoyed by the trunk lid vibrations when riding on bumpy roads. Problem solved. The installation was as easy as advertised the the trunk is now quiet. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.17.2009
5 Stars
Perfect! Yes - be careful while installing - follow the directions carefully and patiently (there is an extra and I had to use it)! This, coupled with Steve Saunders solution, is the bomb! Take a look: https://www.goldwingfacts.com/1800trunklidfix.htm Good stuff! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.14.2009
5 Stars
I've had these bumpers installed for the past 3 years and they are every bit as good as advertised! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.14.2009
5 Stars
I think the product is great and RELATIVELY easy to install. I say relatively because you really, truly, absolutely, MUST FOLLOW THE INSTRUCTIONS! I thought I was, but as it turns out I was pulling the bumper end too hard and too fast. DO NOT DO THAT! If you take it nice and slow (and don't pull too hard) as the instructions state, the installation is a SNAP. In my case I was very thankful that a spare bumper had been included in the package. Once the bumpers were installed they work as advertised. I wish I had known about them a year ago when I brought my 2008 GL1800. I could have avoided the wear now evident on my trunk lid edges. This is an excellent product and as many have said, should be standard equipment on Gold Wings. I highly recommend it. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.08.2009
5 Stars
I have been searching for these for several months ever since my friend told me about them. I couldn't find them anywhere so I put the thought aside. Thanks Wingstuff for finding this product. I should have known you would come through sooner or later. As for the bumpers, a definite must have. Cheap insurance against a scuffed trunk. The install was easy and the spare wasn't needed. Next time you go shopping, throw these in your cart. |