TOP REVIEWED
-
Rubber Baby Buggy Bumpers for GL1800
By Pakit Rak SKU: PRRBBB
- $12.99
-
-
-
Your Bike
Will this fit your bike?
-
172 Member Reviews
1 Star: 16
2 Stars: 10
3 Stars: 8
4 Stars: 33
5 Stars: 105
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
01.08.2010
5 Stars
These work well to make the trunk close tight and not rattle or rub. Installing them is a little tricky, the saliva works but I also tapped them with a rubber mallet to get them to set. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
01.01.2010
5 Stars
Just installed these and they sure make the trunk lid close tightly. Installation was very simple and straight forward. I used a step drill to cut the holes so no sharp or rough edges. Make sure you read the instructions and I must agree with the manufacture spit (saliva) does work best for the install. Honda should have something like this as an OEM from the factory - but I guess they cot corners to increase their profit margin. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.31.2009
5 Stars
I got these just before Christmas. They were easy to install. I cut the edges of the template and matched the line on the top to the front edge of the trunk. I drilled the holes nice and slow and it minimized the sharp edges. It makes the trunk lid sit correctly, but it will take some pressing down on the lid to get it shut and open for a while until the bumpers compress a little. I used a pair of needle nose pliers to pull on the bottom of the bumper and yes spit and a small round metal rod to help push the top through the hole. Took about 30 min to install from drilling to done. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.30.2009
5 Stars
Got them for Christmas. Hope they work as well as everyone says. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.23.2009
5 Stars
work great and about a 10 minute job. Wish I had these a couple years earlier to help save the paint. Very tight fit but no movement and will hopefully wear down a little. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.19.2009
4 Stars
Great product, trunk is more tight than I like, but dosen't rattle or rub paint anymore.. Gave it a 4 rating, only because the pattern sent with it to drill holes, doesn't say if you have to cut at top of line,facing front? Just says to cut on dotted line, and there is a 1/8 gap at top of pattern, so dont know if it should be trimmed off or left on,,,I trimmed, and sets hole father down on truck, it works, but don't know if inventor wanted it up higher or lower? Im sure it will loosen up on yightness as it stays closed for while.. Great idea, and agree it should have come from factory! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.18.2009
5 Stars
Such a low cost part and I don't know why Honda don't make it a standard compponent to the motobike. I works very well that it completely eliminates the rattling and when I close the hatch it sounds like a Mercedes Benz door LOL. A good thing . |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.13.2009
5 Stars
Work perfect, especially if you have rack on, no more lid movement, simple install, don't worry, just drill on the marks you make, I used a finishing nail and a tack hammer to mark the spots. |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.09.2009
5 Stars
Installation was easy and as everyone else stated here, they should be standard equipment from Honda. Now my trunk lid closes properly and no more scratched paint. Buy these for your GL1800, you need them! John |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
12.02.2009
5 Stars
This is a very inexpensive yet effective remedy to the trunk lid chaffing and rattling problem on the 1800’s. I followed the installation instructions precisely and my installation was very smooth, taking only about 15 minutes. TIP: Dishwashing liquid (recommended in the instructions) as a lubricant did make the insertion of the bumpers fairly easy. Bottom line, it’s a clean look AND it works! Great product!!! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.29.2009
5 Stars
They work great.My trunk is no longer getting the paint scuffed off.The only problem is if you use your trunk remote.It pops open hard you can tell its stressed.The directions do tell you to hold you hand on trunk and push down when opening.I do that and have had no problems. Just wish I had them from day one! |
Rubber Baby Buggy Bumpers for GL1800
ITEM CODE: PRRBBB, SKU: PRRBBB
11.26.2009
5 Stars
When I bought my 2004 I was very annoyed by the trunk lid vibrations when riding on bumpy roads. Problem solved. The installation was as easy as advertised the the trunk is now quiet. |