Contact Us
| I had the floorboards and heel/toe shifter on my 87 Aspencade and liked it a lot. However, my 08 Wing sits a bit lower and forces me to lift my foot higher to reach it. So, I took it off. Worked very well otherwise. For that it gets 5 stars. |
| Very nice addition to the bike. Wife loves it. Nice fold-away cup holder is convenient. They open out-ward to for the passenger to get on and to open the trunk lid. |
| I have a mustache, thought my bike should too. lol |
| These lights are awesome look sharp. I had one burn out due to short in wire where it goes thru cover. kuryakyn replaced no charge lights are guarenteed. Get the red one for the rear reflector it's sharp also. |
| Heavy duty mount. The chrome looks way better than the factory gray. A must have with the Kuryakyn pegs |
| The smoke looks great on my 2 silver helmets, blocks the wind greatly, but tough to use the intercom system. |
| Broken tab right out of the box where the screw goes in. Look's great on the bike, but be careful installing these because they are fragle. |
| Great product. Would have taken only 30 minutes to install, but the brake shaft pushed in when I tried to install the new lever. Since my trike has Aqua Shields, (running boards) there is no way to get behind the shaft to push it out. so.....it turned into a 2 hour, 6 beer job. Would have been a 1 hour job without the beer tho. |
| Great product. Would have taken only 30 minutes to install, but the brake shaft pushed in when I tried to install the new lever. Since my trike has Aqua Shields, (running boards) there is no way to get behind the shaft to push it out. so.....it turned into a 2 hour, 6 beer job. Would have be a 1 hour job without the beer tho. |
| Safety is always on my mind when riding in traffic where safety is not on the mind of the other car operators. That is why I decided to put this in my bike. The instructions are not helpful for putting on the wing, just very basic description. Fortunatly I have the manual and tracked down the wiring locations, wire color, etc. Actual installation time was about 2.5 hrs. The rear brake light wiring (L and R) is located behind the rear fender behind the license plate. A blue wire coupler (R) and a red coupler (L), each with a green wire with a red stripe are the brake light wires. Cut the wires per instructions, run a ground wire and test. Works great and hope it wakes up the other drivers. |
| Recieved this as a Christmas gift. It was simple to install - really easy if you get a second pair of hands when installing the seat into the bracket. One problem - it is so comfortable you may ride for days! |
| Easy to install and look great, the fit was a little off. The left side scratched when folded up. Not a big deal but you think Kury could have fixed this by now. |