GL1800 Chrome LED Lighted License Filler Plate

MAN DOES IT DRESS THAT REAR END UP LOOKS GREAT AND MORE LIGHT

if you want to add something to the back end of your wing...you have to put this on....easy to install but take your time since you are mounting over the paint... you don't want scatches because you are in a hurry...If you are like me...even if the chome covers them it will annoy the shit out of you....

Another made in Japan piece from Add On. The instructions don't address the installation of the wires. I removed the rubber grommet from the fender and ran the wires thru the hole in the fender. I then reversed the grommet and installed it between the new chrome piece and the fender. Hopefully this will prevent dust and rain from getting in from behind the the fender. Also didn't use the two sided tape because if someone out there has any idea of the proper way to install the wiring, I'll be able to remove the piece to install correctly. Add On needs to spend some time editting their instructions.

i like everthing about it / put i dont like putting my insp.sticker on my paint /can you had something to it so you can put it on it thanks

I like it - I had a different lighted license holder for the past 5 years, but this one looks more classy, and fills in the large void in the rear center panel nicely. It assembled easily, and the directions made sense to me, so it went on easily.