GL1800 Accessories 50-Watt Mini Halogen Driving Lights

1 * for the look, and that is about it. The lighting provided is quite unsufficient, those are more about being seen than anything else.
As said by others, they are NOT waterproof, and the brackets are just a joke. Save your $ and avoid. I guess I 'll fabricate my own brackets and use some H3 small lights from Walmart.

Based on the other reviews, I don't plan to buy one. The Solution to blinding drivers is to put a relay in that would be wired to the High Beam side of your switch. that way they would only come on with high beam & not with low beams. Same way Fog lights are wired only with the low beams.

I did not purchase this item through Wing Stuff. I went through AAFES thinking I would save some money. Did not happen, Wing Stuff can not be beat. These lights look good and are bright. The mounting bracket is sufficient. The adjustment screws are a little hard to get to once the light has been installed. The little lights add more light which makes us more visible.

The main attraction of these lights is that they look good. The beam is ok, but the under-dimensioned mounting brackets make them vibrate too much. It is probably only a matter of time before they brake. Having read Mikes review I instructed my mechanic to seal the wire opening properly. He sealed them carefully, but still one of the lights was filled with water after the first heavy rain. If I had to do it all over again I would probable spend more money and buy the PIAA lights.

These are very bright little lights that will definitely light up the road. The beam is not concentrated so you can not aim them very well. You may also want to turn them off to oncoming traffic. I had a lot of high beam flashes from other drivers. The mounting brackets fit well but could be a bit thicker to prevent the lights from vibrating. The supplied plastic push pins used to mount the brackets to the bike were very brittle. It took very little pressure to break them while pushing the pin into the housing. I contacted the manufacturer and they quickly shipped me their solution. Since the lights are mounted inverted don’t forget to seal the opening in for the wires or the housings will fill with water. Bulb replacement is simple and under $6. Wiring was straight forward with plenty of length to mount the switch anywhere on the bike. They look great and add safety as long as you don’t blind other drivers.