Showing Results 1 - 20 of 20
Product Reviews by pkford
 |
Rating:
I change my oil every 4k, the first change I removed the cowl, I bought this wrench and have not had to pull the cowl for the last 3 changes... Inexpensive, and works well. If you change your own oil this is a must to have! 
|
 |
Rating:
Just tried it and I'm happy with the product... cleans well and feels like it does add a wax or polish to the windshield, and body.. I'll have to try some water to see if it beeds up and off..
|
 |
Rating:
On my 4th oil change at every 4k, bought my first oem filter at honda..... I now buy the same filter here for a lot less...
|
 |
Rating:
Ran 4k on this HP4, improved the shift, and didn't noitce the loud clunk when shifting in hot ambient temps. Just bought a case of it for my next 3 oil changes
|
 |
Rating:
Nice fit, looks great.. priced right!
|
 |
Rating:
Just installed it and cleaned up a lot of items in my trunk. Priced right and makes the trunk area loot clean and organized..
|
 |
Rating:
A good friend had bought 2 sets of these, and gave me 1 set...
I just installed it today... First they look great! but do wish the 06 and up addapter wiring had been included! No trouble to install, and took a little over a 1/2 hour. I think they could have run the wiring out the back (sticker side) rather than out the end so the wiring could be hidden, this would given it a better look... But over all works as intended, and looks great... even better at night. |
 |
Rating:
Great looks, for the price and not hard at all to install. Makes the frt. of the bike look even better.
|
 |
Rating:
Just installed these fog lamps with the crome crowl... Very impressed with the look. I did watch Steve's vidio and that made it very simple to complete the instlation... The link is http://www.goldwingfacts.com/bikersworkshopmenu.htm
If your doing the instlation your self watch the vidio... you won't be wasting your time! |
|
Rating:
Just installed them to my 07... I took rich's advice and went with the wider tape and some of the provided tape.. The instructions were useless.... couldn't even see where to install the tape. The differecne is very noticable.... Looks 10x's better than before... I don't think with the wider tape I'll have any problems...
|
|
 |
Rating:
Just installed this with the show crome blue fog lamps, both were easy to install. I did watch steve's vidio and that made it simple.... Looks great and yes I did remember to transfer over the slide on nuts... Very happy with the results...
|
 |
Rating:
Its not too hard to install, but do have to take the trunk out side bottom off to run the wires… But just follow the directions and you’ll have no problems… Works as advertised, and I’m happy with the results. Glad to have an extra turn signal higher up.
|
 |
Rating:
Nice looking and very simple to install. I like that the passenger arm rest have a good support, but would like to see a little more adjustment to the back rest… first position is too far forward, the second works best and the third is ok but just a bit too far back for my 5’ 9” height. I also like how the back rest folds forward to allow the passenger easy access. The passenger is a little cramped but the back rest is very easy to remove and still have the passenger arm rests for the shorter trips…
Just came back from a 1200 mile trip down California PCH 1 and 101 to LA and all thou it took a few hundred miles to get used to it, I’m very glad I had it… Made the ride a whole lot more comfortable. Thou a bit expensive from the other back rests its well build and looks good… |
 |
Rating:
Easy to install, had to work the rubber around the coax through the center 3/8 hole but fits snug for a tight seal. No problems routing it down under the seat and into the trunk… I don’t have the C/B radio yet, but like the even balance it gives to the over all appearance of the Goldwing
Well worth the price. |
 |
Rating:
Very good looking, and work like it was intended to.. A bit tricky to install, not only do you have to line up the bottom stops, BUT make sure its centered on the right and left sides so when you press it on, your even on the right and the left sides of the fender. If you want your timing cover, and front cowling free of road dirt, and mud this works well and looks great.
|
 |
Rating:
Here in Nevada temps get into the 100’s I installed this product yesterday, you do feel air flow under you. It seem to keep my back side from sweating and a little cooler, BUT sadly it is no where near as comfortable as the seat itself. I don’t know if I could ride for very many hours on it. I guess it’s a give and take… ride without a sweaty back side and be uncomfortable, or ride with a sweaty, hot and sticky back side and still be uncomfortable but able to ride on longer trips.. For the price it ok, and for hot days and short 1 hr. trips its ok. If it was made with s soft foam or rubber coating, and a little larger to make it more comfortable then it would be well worth it. 
|
 |
Rating:
Easy to install, and LOOKS GREAT!, gives that little extra added touch to the overall appearance.. Very happy with them.
|
 |
Rating:
Very easy installation, and did stiffen up the feel and turning…It looks very nice even with out the dust covers, I had to wait for the dust covers while wingstuff fixed the attachment problem, but the covers just came today, but I haven’t installed them as of this post.
Excellent product, and I can’t figure why Honda doesn’t put these on all Glodwings as a factory item… |
 |
Rating:
I just installed this factory spoiler, instructions were very easy to follow. I looks great! I also bought the GL1800 Kisan TailBlazer Rear Brake Running & Spoiler Modulator along with the Honda GL1800 Accessory Luggage Rack.. It was simple plug in for the modulator, and the spoiler now works as running lights and attention getting brake lights… I would highly recommend this as a must have for the added safety… and looks.
|
 |
Rating:
Bought this rack, and the spoiler at the same time, the installation instructions of this rack were just a little off. It said to have the rack forward but not touching the seat back. I installed the rack as per instructions, then went to install the spoiler… Didn’t fit. I had to move the rack forward ¼ inch pushed up against the seat back to allow room for the spoiler. Other than that minor problem I very happy with the look and the style. I also bought the star washers for the added support, and they not only look good but do add a sturdier feel to the rack.
I'd give a 5 for the looks and style, but for the minor error in the instructions I have to give a 4.. For anyone else, Install the spoiler first then the rack |
